Flexsim新模型-“Heatmap Module ”

原帖地址：http://www.flexsim.com/community/forum/showthread.php?t=2881
! G4 `# O- J( X0 J: J9 i
: `* @6 C0 i& p. C/ K7 k: ]下载模型可以去原帖上面进行~~~

( V3 ^. `+ [; X4 o# j节选里面的模型作用介绍
% F/ Z. x) n4 ?; X+ D2 }“Hi community!
8 @( Z5 E4 U" y0 ^ I've a little something for you ;-) I've developed a little module to show a heatmap in our models. It's brandnew and still beta but I'm interested in our opinion.


Restrictions for this beta:
- no gui
" G% V( r+ y5 P  y! _ - only for 64 bit
- tested only with FlexSim GP 7.1.4 64bit on a Windows 7 64bit


How to install?
Unzip file to modules folder in flexsim.

# N7 d: i# e5 ^: j8 }2 u& x
0 o9 ^. ]/ w8 f How to use?
7 v: i' o. z" W2 y; f9 k# I) L6 a  Z Just drag your new HeatmapTicker object into your model. That's it.


1 v1 z6 ]$ L. A What does this module?
/ Z( g3 N( \( G- I/ c This module draw a heatmap in your model. It collects the location of your taskexecuters for each tick of the heatmapticker. This shows you how often a location was used. Red means a hot area and blue a cold area.
Which settings options are available?
) F# d3 w$ J* a Even without a gui you have several options to configure your heatmap. You have to access your heatmapticker with the tree view. The settings are in the variables node:
2 l) r+ e& k# d5 U* f8 D/ l - ticktime -> time interval to add the actual location of your taskexecuters
2 k1 V2 R7 Z9 ?$ C - gridsizeX -> area in x to summarize locations
3 E) s! O3 r4 _  c0 Q - gridsizeY -> area in y to summarize locations
$ T  U4 M" g9 {  M - sizeZ -> if greater than 0, your heatmap goes up in the sky
- objectList -> only for your information, which taskexecuters are registered for the heatmap (robot and elevators aren't added)
( [8 H5 x+ u) r9 ]( Y* \! t - mesh -> heatmap drawing, don't touch
You can make you heatmap invisible if you use the flexsim command switch_hideshape.


Hints:
- very small ticktime, gridsizeX and/or gridsizeY boost your cpu usage
6 i/ |, R. @" N - only taskexecuters in the model tree will be recognized
# u9 H5 V6 k- |/ ?) s - only used locations will be stored -> no restrictions for locations
- the colors and optional heights aren't linear -> a natural logarithm will be used with the measured data to make the heatmap more visible
/ d$ r5 ?: W1 _
7 R8 @& y/ e4 I I'm curious about your thoughts and hints. Of course you'll get the final version also. Did I mentioned that it's free?
”

强大，谢谢楼主！

狂霸酷帅拽。

好东西，flexsim真强大啊！